RANGE – P NEETER DRIVE BEVEL GEARBOXES

Range – P Series 2000 Manual Disengage/Reversing

General Design Features

Generally comprising of the same basic design characteristics as the range of right angle gearboxes with the added facility, within the housing, for manual disconnection or “reversed rotation” re-engagement of the output drive shaft. This is effected by hand rotation of a control knob located on one side of the housing to provide 3 positive control positions. The control knob can engage with the power train of 3 straight bevel gears.

“Central position” the drive output is fully disconnected allowing it to “idle” or “free-wheel”

“Left-position” engagement in one direction to provide forward output rotation.

“Right position” engagement in the other direction to provide reverse output rotation.

Note: manual engagement & disengagement must ONLY be carried out when all shafts and, particularly, the output shafts are stationary (unless, both driving and driven inertias are small – and, even then, speeds should not exceed 200 RPM).